E-flite Cessna 150 Aerobat 250 ARF Bedienungsanleitung PDF herunterladen (Seite 8)

8 E-flite Cessna 150 Aerobat 250 ARF Assembly Manual

 15. With the aileron servo centered, attach the

Z-bend of the pushrod to the control horn.

 16. Pass the pushrod through the pushrod connector

and center the aileron. Use a #1 Phillips screwdriver

to tighten the screw in the pushrod connector to

secure the pushrod wire. Use side cutters to remove

the excess wire. Support the clevis and the wire

while doing this to not damage the model.

 17. Repeat steps 2 through 16 to install the

remaining aileron servo.

 18. Check to make sure the radio system has been

turned off before proceeding.

Rudder and Elevator Servo Installation

Required Parts

Fuselage Servo with hardware (2)

3-inch (76mm) servo extension (2)

Required Tools and Adhesives

Pencil Phillips screwdriver: #0

Pin vise Drill bit: #56.046-inch (1mm)

Thin CA Dental floss

 1. Remove the battery hatch cover from the fuselage

by sliding the locking pin forward. The front of the

hatch is held in place by a tab at the front. Set the

cover aside until it is required later in the manual.

 2. Prepare the rudder and elevator servos by using

a #0 Phillips screwdriver to remove the servo horns

from the servos. Attach the mounting bracket to the

servos as shown.

Rudder Elevator

 3. Position the rudder servo in the fuselage. Locate

the servo so the outer edge is against the outer

edge of the mounting rail and centered between the

front and rear. Use a pencil to mark the locations

for the two mounting screws.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Keine Kommentare

E-flite Cessna 150 Aerobat 250 ARF Bedienungsanleitung Seite 8