E-flite Mini Ultra Stick ARF Programming Guide Bedienungsanleitung PDF herunterladen

Programming Guide for the JR XP7202 for the Hangar 9 Ultra Stick

To start with, plug your servos into the correct channels. Below is a listing of what servo to plug

into each channel. You will need a 7-channel receiver to use the full set up that the 7202 is capable of

doing with the Ultra Stick.

Ch. 1 Throttle Ch. 5 Left Aileron (Listed as Gear Channel on Receiver)

Ch. 2 Right Aileron Ch. 6 Right Flap (Listed as Aux 1 on Receiver)

Ch. 3 Elevator Ch. 7 Left Flap (Listed as Aux 2 on Receiver)

Ch. 4 Rudder

System Set-Up Mode

To begin setting up the transmitter, press and hold the down and select keys, and turn the 7202

on, then release the down and select keys.

Model Selection

Press the up or down key until Model Select is on the top of the screen, and select the model you want

the ultra stick on by pressing the increase or decrease key.

Model Reset

Press the up key and scroll through the menu options until you get to Model Reset. With the arrow

pointing at data reset, press the clear key.

Model Type Selection

Press the down key until you get to the Type Select function. Press the increase or decrease button until

the arrow points at ACRO. If you change this from heli, it will then request you to press the clear key to

say yes to change the model type.

Modulation Selection

Set the modulation as needed to match your receiver by pressing the up key to get to the Modulation

function, and select the modulation needed by pressing the increase or decrease keys.

Input Select Set Up

Press the up key until you get to the Input Select function. With the arrow pointing at Aux2, press the

increase key until it says INH next to Aux2. Press the select key and the arrow should now point at

1 2 3 4 5

Programming Guide for the JR XP7202 for the Hangar 9 Ultra Stick To start with, plug your servos into the correct channels. Below is a listing

Aux2 Trim, this should say INH, if it does not, press the increase key until it does. Press the select key again and the arrow should point at Flap.

Seite 3

25% on elevator and rudder is recommended to start with. Set your low rates around 70% to start with, and change to your tastes. Servo Reversing Se

Seite 4

this value, you will set this value as needed to get the flap travel needed with the switch in the land position. Next press select so that the arrow

Seite 5

says something other than ON, press the select key to make the arrow point at SW, and press the increase key until it says ON. To set up the second m

Keine Kommentare

E-flite Mini Ultra Stick ARF Programming Guide Bedienungsanleitung