E-flite UMX Pitts S-1S BNF Basic Bedienungsanleitung PDF herunterladen (Seite 8)

Post Flight Checklist



1. Disconnect the ﬂ ight battery from the ESC

(Required for safety and battery life).

2. Power OFF the transmitter.

3. Remove the ﬂ ight battery from the

aircraft.

4. Recharge the ﬂ ight battery.



5. Store the ﬂ ight battery apart from the

aircraft and monitor the battery charge.

6. Make note of the ﬂ ight conditions and

ﬂ ight plan results, planning for future

ﬂ ights.

We recommend ﬂ ying your aircraft outside in calm

conditions. Always avoid ﬂ ying near houses, trees,

wires and buildings. You should also be careful to

avoid ﬂ ying in areas where there are many people,

such as busy parks, schoolyards or soccer ﬁ elds.

Consult local laws and ordinances before choosing

a location to ﬂ y your aircraft.

Takeoff

Place the aircraft in position for takeoff (facing into

the wind if ﬂ ying outdoors). Set dual rates to low

position and gradually increase the throttle to ¾ to

full and steer with the rudder. Pull back gently on

the elevator and climb to check trim. Once the trim

is adjusted, begin exploring the ﬂ ight envelope of

the aircraft.

Landing

Land into the wind. This is very important for this

model. Fly the aircraft to approximately 6 inches

(15cm) or less above the runway, using a small

amount of throttle for the entire descent. Keep the

throttle on until the aircraft is ready to ﬂ are. During

ﬂ are, keep the wings level and the airplane pointed

into the wind. Gently lower the throttle while pulling

back on the elevator to bring the aircraft down on

all three wheels.

Failure to lower the throttle stick

and trim to the lowest possible

positions during a crash could

result in damage to the ESC in

the receiver unit, which may

require replacement.

This aircraft is equipped with

Over Current Protection (OCP).

This feature protects the ESC

from overheating. OCP stops the

motor when the transmitter throttle is set too high

and the propeller cannot turn. The OCP will only

activate when the throttle stick is positioned just

above 1/2 throttle. After the ESC stops the motor,

fully lower the throttle to re-arm the ESC.

NOTICE: Crash damage is not covered under the

warranty.

Repairs

Repair the aircraft using foam-compatible CA

(cyanoacrylate adhesive) or clear tape. Only use

foam-compatible CA, as other types of glue can

damage the foam. When parts are not repairable,

see the Replacement Parts List for ordering by

item number.

For a listing of all replacement and optional parts,

refer to the list at the end of this manual.

NOTICE: Use of foam-compatible CA accelerant on

your aircraft can damage paint. DO NOT handle the

aircraft until the accelerant fully dries.

NOTICE: When you are ﬁ nished ﬂ ying, never leave

the aircraft in direct sunlight or in a hot, enclosed

area such as a car. Doing so can damage the foam.

Flying Tips and Repairs

Always

decrease throttle at

propeller strike.

CAUTION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

E-flite UMX Pitts S-1S BNF Basic Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftausrüstung E-flite UMX Pitts S-1S BNF Basic