E-flite P-38/F-5E Lightning 400 ARF Bedienungsanleitung Seite 1

SpecificationsWingspan: 48 in (1219mm)Length: 35 in (889mm)Wing Area: 307 sq in (19.8 sq dm)Weight w/o Battery: 28–35 oz (794–992 g)Weight w/Batte

10 E-flite P-38/F-5E Lightning Assembly Manual 4. Thread the clevis back onto the pushrod wire. 5. Secure a 12 in (305mm) servo extension onto the

11E-flite P-38/F-5E Lightning Assembly Manual 7. Position the elevator servo in the servo tray on the side with the "S9" decal with the ou

12 E-flite P-38/F-5E Lightning Assembly Manual 11. With the radio system still powered on, attach the pushrod wire to the servo arm. It may be nece

13E-flite P-38/F-5E Lightning Assembly ManualRudder Installation (Optional)Required Parts• Fuselage/center section assembly• CA hinge (6) • Y-harness

14 E-flite P-38/F-5E Lightning Assembly Manual  3. If using medium foam-safe CA, apply a small amount to one half of the hinge. Make sure to apply

15E-flite P-38/F-5E Lightning Assembly Manual  5. Attach the control horn to the outside of the rudder using the backplate and two 2mm x 12mm screw

16 E-flite P-38/F-5E Lightning Assembly Manual  8. Test fit the rudder. Check that it can move freely without binding against the elevator. Trim the

17E-flite P-38/F-5E Lightning Assembly Manual 10. Repeat Steps 1 though 9 to install the second rudder servo. The control horn is mounted on the rud

18 E-flite P-38/F-5E Lightning Assembly ManualBrushless Motor InstallationRequired Parts• Fuselage/center section assembly• Brushless outrunner motor

19E-flite P-38/F-5E Lightning Assembly ManualHint: Use a hobby knife to cut a notch in the boom so you can use the razor saw to cut the mount.Note: Th

2 E-flite P-38/F-5E Lightning Assembly ManualIntroductionThank you for purchasing the E-flite® P-38/F-5E Lightning 400 ARF. The P-38/F-5E is a highly d

20 E-flite P-38/F-5E Lightning Assembly Manual  5. Solder both sets of motor leads together with a male EC3 connector. Make sure to solder the posi

21E-flite P-38/F-5E Lightning Assembly ManualNote: Never check the motor rotation on the bench with the propeller installed. The plane could move and

22 E-flite P-38/F-5E Lightning Assembly Manual  8. Snap the spinner cone onto the spinner backplate. 9. Repeat Steps 1 through 8 to install the r

23E-flite P-38/F-5E Lightning Assembly Manual  2. Install the brushed motor in the gearbox using the hardware provided with the gearbox. Check the

24 E-flite P-38/F-5E Lightning Assembly Manual 5. Install the speed control inside the fuselage. Solder both sets of motor leads to the speed contro

25E-flite P-38/F-5E Lightning Assembly Manual  7. Remove the backing from the double-sided tape on the sides of the boom. Slide the cowling onto th

26 E-flite P-38/F-5E Lightning Assembly Manual  9. Snap the spinner cone onto the spinner backplate. 10. Repeat Steps 6 through 9 to install the

27E-flite P-38/F-5E Lightning Assembly Manual  2. Turn on the transmitter and apply power to the receiver. Check that the aileron servo is operatin

28 E-flite P-38/F-5E Lightning Assembly Manual  5. Attach the aileron servo pushrod and linkage as shown.  6. Plug the servo extension and serv

29E-flite P-38/F-5E Lightning Assembly Manual 9. Remove the backing from the pre-installed double-sided tape on the center section cover. Position t

3E-flite P-38/F-5E Lightning Assembly ManualUsing the ManualThis manual is divided into sections to help make assembly easier to understand, and to pr

30 E-flite P-38/F-5E Lightning Assembly Manual 2. Slide the nose gear into position.  3. Place a piece of double-sided tape onto the bottom of th

31E-flite P-38/F-5E Lightning Assembly Manual 4. Use glue to install the drop tanks permanently, or use double-sided tape so they can be removed in

32 E-flite P-38/F-5E Lightning Assembly Manual 2. Install the receiver battery and switch in the fuselage and plug the switch into the receiver. Or,

33E-flite P-38/F-5E Lightning Assembly ManualCenter of GravityAn important part of preparing the aircraft for flight is properly balancing the model.Ca

34 E-flite P-38/F-5E Lightning Assembly Manual 5. Once the control throws have been verified, slide the clevis retainers onto the clevises to preven

35E-flite P-38/F-5E Lightning Assembly Manual2007 Official AMA National Model Aircraft Safety CodeGENERAL1) I will not fly my model aircraft in sanc

9941© 2007 Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 horizonhobby.com E-fliteRC.com

4 E-flite P-38/F-5E Lightning Assembly ManualYou will need a 3-channel or greater transmitter (at least 4-channel with optional rudders and/or steerab

5E-flite P-38/F-5E Lightning Assembly ManualImportant Information About Motor SelectionThe P-38/F-5E has been extensively tested with the motors and p

6 E-flite P-38/F-5E Lightning Assembly ManualRequired Tools and AdhesivesTools & Equipment#0 Phillips Screwdriver (EFLA258)#1 Phillips Screwdriver

7E-flite P-38/F-5E Lightning Assembly ManualDamage LimitsHORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS O

8 E-flite P-38/F-5E Lightning Assembly ManualNon-Warranty RepairsShould your repair not be covered by warranty the repair will be completed and paymen

9E-flite P-38/F-5E Lightning Assembly ManualElevator Servo InstallationRequired Parts• Fuselage/center section assembly• Double-sided tape • Receiver