E-flite UMX AS3Xtra BNF Basic Bedienungsanleitung PDF herunterladen (Seite 12)

AS3X

Problem Possible Cause Solution

Control surfaces not at

neutral position when

transmitter controls are

at neutral

Control surfaces may not have been

mechanically centered from factory

Center control surfaces mechanically by

adjusting the U-bends on control linkages

ESC/receiver does

not arm when the

battery is connected

Aircraft was not kept immobile for 5

seconds

Disconnect and reconnect the ﬂ ight

battery while keeping the aircraft still for

5 seconds with throttle sitck in lowest

position.

Aircraft oscillates in

fast forward ﬂ ight

Incorrect ﬂ ight mode Decrease throttle, then change to

General Flight or a Standard AS3X ﬂ ight

mode

Controls oscillate in

ﬂ ight, (model rapidly

jumps or moves)

Propeller is unbalanced, causing excessive

vibration

Remove propeller and rebalance or replace it

if damaged

Problem Possible Cause Solution

Aircraft will not respond

to throttle but responds

to other controls

Throttle stick and/or throttle trim too high Reset controls with throttle stick and throttle

trim at lowest setting

Throttle channel is reversed Reverse throttle channel on transmitter

Motor disconnected from receiver Open fuselage and make sure motor is

connected to the receiver

Extra propeller noise or

extra vibration

Damaged propeller, spinner or motor Replace damaged parts

Prop screw is too loose Tighten the prop screw

Prop is out of balance Remove and balance propeller, or replace

with a balanced propeller.

Reduced ﬂ ight time or

aircraft underpowered

Flight battery charge is low Completely recharge ﬂ ight battery

Propeller installed backwards Install propeller with numbers facing forward

Flight battery damaged Replace ﬂ ight battery and follow ﬂ ight battery

instructions

Flight conditions may be too cold Make sure battery is warm before use

Battery capacity too low for ﬂ ight conditions Replace battery or use a larger capacity

battery

LED on receiver ﬂ ashes

and aircraft will not bind

to transmitter (during

binding)

Transmitter too near aircraft during binding

process

Power off transmitter, move transmitter a

larger distance from aircraft, disconnect and

reconnect ﬂ ight battery to aircraft and follow

binding instructions

Bind switch or button not held long enough

during bind process

Power off transmitter and repeat bind

process. Hold transmitter bind button or

switch until receiver is bound

Aircraft or transmitter is too close to large

metal object, wireless source or another

transmitter

Move aircraft and transmitter to another

location and attempt binding again

Troubleshooting Guide

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

E-flite UMX AS3Xtra BNF Basic Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftausrüstung E-flite UMX AS3Xtra BNF Basic