E-flite Blade mSR BNF Bedienerhandbuch PDF herunterladen (Seite 8)

14 15

Installing the Flight Battery

Once the Li-Po battery has been fully charged, it’s ready to be installed in the

helicopter.

Install the battery in the helicopter by sliding it into the battery mounting supports/

slots just below the main gears. Slide the battery into the slots with the label facing

downward and the connector oriented toward the back of the helicopter.

Note: Be sure to slide the battery into the slots until the endcap of the

battery comes into contact with the rear battery support. This will allow

you to achieve the correct center of gravity for the best overall flight

performance. However, also be sure that the battery is not pushed far

enough forward that it will make contact with the servo gears, as this

could cause damage to the gears and a potential crash.

Important: In the event of a hard landing or crash, the flight battery may move

slightly. Check the flight battery and ensure it is installed properly

prior to flying. Flying the helicopter with the battery slightly out

of position changes the Center of Gravity and may affect flight

characteristics.

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the 5-in-1 control unit to

recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. It

will be necessary for you to ‘bind’ your chosen Spektrum DSM2 technology equipped

transmitter to the receiver/5-in-1 for proper operation.

The following is a list of some of the Spektrum DSM2 equipped transmitters and

modules that will bind to the receiver/5-in-1 of the Blade mSR BNF:

E-flite LP5DSM Spektrum DX5e

E-flite HP6DSM Spektrum DX6i

ParkZone Vapor Transmitter Spektrum DX7/DX7se

JR X9303 2.4 Spektrum Modules

JR 12X 2.4

Note: The Spektrum DX6 (SPM2460) is equipped with DSM (not DSM2)

technology and is not compatible with the receiver/5-in-1 of the

Blade mSR BNF.

The following steps outline the binding process:

•Confirmtheprocessofenteringthebindmodeforyourchosentransmitterby

reviewing the instruction manual included with the transmitter.

•Makesuretheflightbatteryisdisconnectedfromthe5-in-1unitandthetransmitter

is turned off.

•Plugtheflightbatteryintothe5-in-1unit.After5secondstheLEDonthe5-in1unit

will begin flashing.

•AfterverifyingtheLEDisflashingonthereceiver/5-in-1,followthestepsthatallow

your chosen transmitter to enter bind mode.

•Ifyouenteredbindmodecorrectly,youwillseeasolidLEDapproximately5–10

seconds later on the receiver/5-in-1. You should now be bound to the transmitter,

and have full control and function.

If you encounter any problems, repeat the binding process again or call the Horizon

Support Team at 1-877-504-0233.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

E-flite Blade mSR BNF Bedienerhandbuch Seite 8

Kommentare zu diesen Handbüchern