E-flite UMX Spacewalker Bedienerhandbuch

Instruction ManualBedienungsanleitungManuel d’utilisationManuale di IstruzioniUMX™ Spacewalker

10ENControl Horn SettingsThe table to the right shows the factory settings for the control horns. Fly the aircraft at factory settings before making c

11ENWe recommend fl ying your aircraft inside a large gymnasium. We do not recommend fl ying the aircraft outdoors unless the conditions are absolutely

12ENPower Components Service110 x 60CAUTION: DO NOT handle propeller parts while the fl ight battery is connected. Personal injury could result.Disasse

13ENProblem Possible Cause SolutionAircraft will not respond to throttle but responds to other controlsThrottle stick and/or throttle trim too high R

14ENProblem Possible Cause SolutionMotor loses power Damage to motor or power components Do a check of motor and power components for damage (replace

15ENWarranty and Service InformationCountry of Purchase Horizon Hobby Phone Number/Email Address AddressUnited States of AmericaHorizon Service Center

16ENDeclaration of ConformityCompliance Information for the European UnionRobert PeakChief Financial Offi cerHorizon Hobby, LLCInstructions for disposa

61Replacement Parts – Ersatzteile – – Pièces de rechange – Pezzi di ricambio –Part # • Nummer Numéro • CodiceDescription Beschreibung Description Desc

62– Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Pezzi opzionali e accessori –Par

© 2014 Horizon Hobby, LLC.E-fl ite, Celectra, UMX, DSM, DSM2, DSMX, ModelMatch, Bind-N-Fly, the BNF logo and the Horizon Hobby logo are trademarks or r

2EN WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product c

3ENTo register your product online, go to www.e-fl iterc.com11.6 in (295mm)16.5 in (418mm) Weight: 0.78 oz (22 g)Wing Area: 45.3 in2 (292 dm 2)Table of

4EN1. Charge fl ight battery.2. Install fl ight battery in aircraft (once it has been fully charged).3. Bind aircraft to transmitter. (BNF only)4.

5ENYour aircraft comes with a 1S 3.7V DC Li-Po battery charger and 1S 3.7V 70mAh 14C Li-Po battery. Refer to the charging warnings. It is recommended

6ENBinding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single specifi c transmitter. You ne

7ENThe E-fl ite® 4-channel DSM2/DSMX transmitter features digital trim buttons on all controls to make fi ne adjustments. The digital trims are used to

8ENFlight Battery Installation and ESC ArmingArming the ESC also occurs after binding as previously described, but subsequent connection of a fl ight b

9ENBind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure aircraft control surfaces move corre