E-flite EFL7150 Bedienerhandbuch PDF herunterladen (Seite 8)

Control Surface Centering

After assembly and transmitter setup, conﬁ rm that the control surfaces are

centered. If the control surfaces are not centered, mechanically center the

control surfaces by adjusting the linkages.

If adjustment is required, turn the clevis on the linkage to change the length of

the linkage between the servo arm and the control horn.

After binding a transmitter to the aircraft receiver, set the trims and

sub-trims to 0, then adjust the clevises to center the control surfaces.

Clevis Installation

• Pull the tube from the clevis to the linkage.

• Carefully spread the clevis, then insert the clevis pin into the desired hole in

the control horn.

• Move the tube to hold the clevis on the control horn.

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

NOTICE: If control throws are changed from the factory settings, the AR636

gain values may need to be adjusted. Refer to the Spektrum AR636 manual for

adjustment of gain values.

IMPORTANT: Adjusting the programming of the AR636 receiver is not recom-

mended. If the programming is adjusted the receivers SAFE function could be

compromised. Refer to the AR636 receiver instruction manual online.

After ﬂ ying, you may choose to adjust the linkage positions for the

desired control response.

Horns Arms

Elevator

Rudder

Ailerons

Trimming

IMPORTANT: Only trim this aircraft in Precision Flight Mode.

After adjusting transmitter trim in the air or on the ground, do not touch the

control sticks for 2 seconds. This allows the receiver to learn the correct

settings to optimize AS3X performance.

Failure to do so could affect ﬂ ight performance.

2 Seconds

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Keine Kommentare

E-flite EFL7150 Bedienerhandbuch Seite 8