E-flite Carbon-Z Cub PNP Bedienungsanleitung PDF herunterladen (Seite 15)

Control Surface Centering

AS3X Control Direction Test

IMPORTANT: Perform the Control Direction Test before performing control

surface centering.

Control Surface Centering and Adjusting a Linkage

While AS3X is inactive (before advancing the throttle), mechanically center the

control surfaces.

IMPORTANT: Correct operation of the AS3X system requires sub-trim and

trim at 0.

After binding a transmitter to the airplanes receiver, set the trims and sub-trims

to 0, ensure the servo arms are in the correct positions, then adjust the link-

ages to center the control surfaces.

Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or

install a link on a control horn.

• Turn the linkage clock-

wise or counterclockwise

until the control surface is

centered.

• Attach the linkage to the

servo arm or control horn

after adjustment.

Assemble the aircraft and bind your transmitter to the receiver before perform-

ing this Test.

Activate the AS3X system by advancing the throttle to 25%, then fully lowering

the throttle.

Move the aircraft as shown to ensure the AS3X system moves the control sur-

faces in their proper direction. If the control surfaces do not respond as shown,

do not ﬂ y the aircraft. Refer to the receiver manual for more information.

Once the AS3X system is active, the control surfaces may move rapidly on the

aircraft. This is normal. AS3X will remain active until the battery is discon-

nected.

Aircraft

movement

AS3X Reaction

ElevatorAileronRudder

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Keine Kommentare

E-flite Carbon-Z Cub PNP Bedienungsanleitung Seite 15